 
|
Improved spurious adjacent signal rejection
The MRF-350 receives Narrow Band RF (radio
frequency) signals via the RFX-250 RF Sensor
(antenna module). The RFX-250 displays RF
interference via a bright red LED which flickers
when interference is present. Simply relocate the
RFX-250 out of the interference area to resolve the
problem.
Expand Range
You can expand the range by adding additional
RFX-250 RF Sensors in remote areas. The MRF-350 can
power up to three RFX-250 RF Sensors connected in
parallel to the RF Input connector.
|
 |
Variable IR output matches rear panel inputs
The MRF-350 is equipped with adjustable IR line
outputs. Each output can be individually matched to
rear panel IR inputs on any component that is
designed to be operated by a standard IR repeater.
The outputs utilize a 3.5 mm jack.
Control Identical Equipments
You can control six identical components or zones —
Up to fifteen MRF-350s in the same installation. The
MRF-350 has six “addressable” IR Line Outputs. For
example, you can control up to six identical TVs
with one MRF-350 or route volume commands for a
specific zone to a particular zone IR input on a
multi-zone pre-amp. If you have more than six
identical components or zones, up to 15 MRF-350s can
be separately installed to control them—thereby
allowing up to 90 identical components or zones in
one house.
The MRF-350 is compatible with the MX-6000, MX-3000,
MX-980, TX-1000, MX-950 and MX-900, MX-880, MX-850,
MX-810, MX-650, MX-450, MX-350 universal remote
control. Each can be programmed to specifically
control components in a particular room by
installing a base station at each location. In
operation, it’s simple: when you select a device
located in the Den, the remote only send commands to
the Den. When you select a device located in the
Family Room, the remote only sends commands to it.
IR Input for multi-zone loop through, keypads or
IR repeater systems
The MRF-350’s rear panel IR input will relay IR data
from IR repeaters or multi-zone keypads to all IR
line outputs (does not support IR routing). The 5V,
100mA output will power some keypads directly. |
|
