Stealth Model AX3 Invisible In-Wall Speaker
Three-Way Totally Invisible In-Wall or Ceiling Loudspeaker
The
Stealth Acoustics model AX3 is a three-way, full-range
loudspeaker system that becomes completely invisible after
installation. The loudspeaker has a rigid frame which
attaches directly to standard structural framing without the
need for special mounting brackets. The paintable active
diaphragm face is a structurally modified three layer
composite consisting of two layers of graphics grade paper
with a foam core. The diaphragm is bonded to the frame,
creating an active area surrounded by a stable mounting
area. Basic installation instructions are shown on our
removable cover sheet that comes off before taping and
finishing begins. The face of the panel has been pre-primed
and is ready to receive finishing materials. The edges of
the panel are tapered similar to the edges of gypsum
wallboard, providing the room necessary for normal wallboard
tape and joint compound to be used to feather the speaker
seamlessly into the wall or ceiling. The AX3 loudspeaker
comes equipped to match either 1/2” or 5/8” wallboard
installations. On-site finishing options include latex
paint, covering with light wallpaper, fabrics and selected
texture coats. There is no need for special vellums or other
nonstandard wallboard finishing materials.
Stealth Acoustics speaker invisibility allows for powerful
advantages over other loudspeakers as they can be placed
wherever they sound best, free of visual concerns that may
conflict with architectural features. Stealth Acoustics
offers complete, invisible companion subwoofer solutions for
extended low frequency response.
|
Front view of the Model AX3 In-Wall Speaker. |
Rear view of the Model AX3 In-Wall Speaker. |
Advanced Technologies
The Stealth AX3 is a three-way system, incorporating an
acoustically coupled high quality, high-power 8" cone woofer
and 3 directly-coupled 25mm neo-magnet high/mid-frequency
motors, mounted in a “Balanced Midline Drive tm”
configuration. Advanced internal carbon fiber materials
allow for smooth frequency extension to 20kHz, even with
four coats of paint. As with all Stealth speakers, the
crossover system is over-provisioned to take abuse and is
equipped with self-resetting poly switches to protect the
drivers well below their rated power handling. To further
ensure consistent quality, we test each Stealth speaker with
computer analysis and a listening test before they are
released for shipment.
Specifications:
Nominal Impedance: 4 ohm
Power capacity: 150 watts RMS
Frequency Response: 40Hz - 20kHz, -4db
Sensitivity: 85db 1 Watt 1 Meter
High Frequency Motor: 25 mm Neodymium
Mid Frequency Motor (x2): 25 mm
Neodymium
Low Frequency Driver: 8” Poly Cone,
1.5” Voice Coil, 8" Woofer
Ceramic 20 oz Magnet
Dimensions: 15-7/8” (403 mm) Wide x
30” (762 mm) High x 3-3/16" (80 mm) deep
Downloads:
Download AX3 Specifications Sheet (PDF)
Technical Data Downloads
Adobe Acrobat Reader
is required to open this file. If you do not
have this software installed, you can get it here:
