Anytronics : Anylight Outstations
‘Flashing’ Alarm Outstation : AL2400
Introduction
The
Anylight alarm outstation is one of a range of remote
outstations manufactured by
Anytronics which are compatible with their Anylight
interface cards fitted inside a dimming
pack. The outstations communicate with the interface card
over a simple two wire interface
and generate the command codes accepted by these interface
cards in order to control
Channel levels and stored Presets.
This panel is designed to draw attention to property by
cycling selected Channel or
Preset lights on and off. The alarm outstation detects the
closure of external voltage free
contacts (eg on a burglar alarm) and cycles the selected
Channel or Preset on and off in a five
second cycle whilst the contacts are closed. When the
contacts open, the Channel or Preset
fades to off.
Key Features of alarm outstation:
Single patress fitting outstation
Channel / Preset addressing set on panel
back
Communication with Anylight interface
card over two wire interface
Channel / Preset address range 1-64
Panel can be configured to provide one of the following:
Channel On/Off cycle control
Preset In/Off cycle control
Downloads:
Download ‘Flashing’ Alarm Outstation : AL2400 Information
(PDF)
Adobe Acrobat Reader
is required to open this file. If you do not
have this software installed, you can get it here:
Anytronics : Anylight Outstations
‘Static’ Alarm Outstation : AL2401
Introduction
The Anylight alarm outstation is one of a
range of remote outstations manufactured by
Anytronics which are compatible with their Anylight
interface cards fitted inside a dimming
pack. The outstations communicate with the interface card
over a simple two wire interface
and generate the command codes accepted by these interface
cards in order to control
Channel levels and stored Presets.
This panel is designed to allow control of a selected
Channel or Preset by a pair of
external voltage free contacts (eg on a fire or smoke
alarm). When the contacts are closed a
selected Channel will quickly fade to full on, or a selected
Preset quickly faded in. When the
contacts open, the Channel or Preset can be set either to
switch off, or to stay on.
Key Features of alarm outstation:
Single
patress fitting outstation
Channel
/ Preset addressing set on panel back
Communication with Anylight interface card over two wire
interface
Channel
/ Preset address range 1-64
Panel can be configured to provide one of the following:
Channel On or On/Off control
Preset In or In/Off control
Downloads:
Download ‘Static’ Alarm Outstation : AL2401 Information
(PDF)
Adobe Acrobat Reader
is required to open this file. If you do not
have this software installed, you can get it here:
